Newport Beach Appliance Repair - (888) 815-1828

Turn the thermostat up to the next highest setting. If it comes on, let it run for 24 hours and check temperature to confirm it is working properly.
Clear/remove anything blocking the air flow around the outside of the refrigerator (on top, underneath, behind, beside, in front of, etc.). Allow 3" of clearance all the way around.
If there are condenser coils on the rear of the box, make sure the box is several inches from the wall and that nothing is on top at the rear, blocking the heat from coming off the coils.

Wipe off the face of the gasket with a wet rag and make sure the interior shelves, drawers and food are not preventing the door from closing from the inside.

Make sure they are sitting straight in their proper positions and check power (Circuit Breaker)

Make sure the water is hot enough. It should be at least 140 degrees, which is hot enough to burn you - VERY HOT! If it is not hot enough, turn the hot water heater thermostat up to a higher setting.
Make sure the lower spray arm is unobstructed and turning freely.
Make sure the bottom inside the dishwasher is clean and free of debris.
Make sure you are following the proper loading procedures. Use the proper amount of detergent and make sure the detergent is fresh (check expiration or "best if used by" date.

Make sure the latch assembly is unrestricted and latching properly. Make sure nothing is blocking the door from opening and closing properly.

Make sure you are following the proper loading procedures, including proper type and amounts of detergents. Run the unit through cycle while empty.
Make sure the racks are positioned properly.
Make sure the door is unrestricted around the opening.

Tech Tip - If the inside of your dishwasher is beginning to brown and form mineral stains, put Limeaway (available at your grocery store) or Tang Citrus Drink into the tank during the wash cycle. The citric acid from these products will remove the mineral buildup and restore the finish.

Make sure the lid is closed properly.
Make sure the timer and all of the controls are set properly.
Make sure both water faucets are turned on.

Tech Tip - Follow the proper loading procedure and machine operation.

Tech Tip - Never overload the machine.

Make sure the dryer is not pushed back against the rear exhaust duct causing an air flow restriction.
Make sure the clothes are coming out of the washer spun damp dry. If the washer is not spinning the clothes damp dry, the dryer will not dry the clothes in a normal amount of time.

Tech Tip - Follow the proper loading procedure and machine operation.

Tech Tip - Never overload the dryer.

Turn the unit off. After turning the unit off, remove anything that has fallen into the grinding chamber.
Turn the unit off. After turning the unit off, insert an "unjamming" tool into the bottom and turn clockwise. Once the tool turns freely, remove whatever was causing the jam.

Tech Tip - Always run water in the sink when you operate the unit.

Check the frost buildup on the inside of the freezer. If it is heavily frosted, manually defrost the freezer by turning it off at the thermostat.

Defrost the unit once a year or as often as needed. Follow the proper defrosting methods. DO NOT USE a knife, pick, hammer, chisel, screwdriver, etc. or any sharp object)

Tech Tip - Follow all procedures outlined under the refrigerator heading.

Tech Tip - Do not pack the freezer.

Always use microwave safe dishes.
Do not use aluminum foil or anything with metal on it. (unless your microwave specifically allows it. Check your owner's manual)
Wipe the seal off with a wet rag and dry it thoroughly as often as needed.
Do not twist, bend, or slam the door in any way.